Current location:

Home >   Products   >   Open-loop stepper motors
LS42A06-B2B20 (2).jpg
LS42A06-B2B20 (3).jpg
LS42A06-B2B20 (4).jpg
LS42A06-B2B20 (5).jpg
LS42A06-B2B20 .jpg

LS42A06-B2B20 Hybrid Stepper Motors

LEESN new generation 42mm*42mm(NEMA17) two-phase 1.8° open-loop stepper motor, compact design, low heating, high stability, high consistency, greater torque, higher performance, recommended for the driver DM420.
① Spindle mode:
Provide single flat, double flat, keyway, hobbing and other shaft delivery modes;
② Lead mode:
According to different application requirements, provide customized winding and routing methods;
③ Accessories selection:
A variety of accessories for stepper motors are available, such as encoders, planetary reducers, power off brakes.
Stepper motor is a kind of mechanical device that converts electrical pulse directly into Angle position, the amount of Angle depends on the number of pulses, it and its matching stepper motor drive device together constitute a set of simple control, but low cost open-loop system.

Matching products

Specification parameters
  • Phase number
  • Step Angle
    1.8 °
  • Step Angle error
    Below ±0.09°
  • Fuselage length
  • Axis length
  • Shaft diameter
  • Rated current
    2.0 A
  • Holding torque
    0.6 N.M
  • Phase resistance
    1.3 Ω
  • Phase inductance
    3.2 mH
  • Moment of inertia
  • weight
  • Service temperature range
    0 ℃ + 50 ℃
  • Service humidity range
    20%RH - 90%RH

Related products